Powder coated aluminium angle 40 x 40 x 4 mm
Product information
The aluminium angle made of EN AW-6060 (AlMgSi0,5) is supplied with a powder-coated surface.
Technical characteristics:
- Material: AlMgSi0,5
- Material number: EN AW-6060
- Surface: powder-coated
- Coating thickness: approx. 60–80 µm
- Delivery condition: T66 (solution heat-treated + artificially aged)
- Manufacturing process: extruded
- Standards: EN 573-3, EN 755-1 / -2 / -9
Surface characteristics:
- uniformly applied coating with closed surface structure
- Gloss level glossy: approx. 80–95 GE
- Gloss level matt: approx. 20–30 GE
- complete coating of the outer legs including the edge areas
Material properties:
- low material density
- high corrosion resistance
- uniform surface quality
- profile-typical precise leg geometry
- good machinability
- non-magnetisable
- suitable for welding and soldering
- food-safe according to EN 602
Note: At the ends of the powder-coated angles, process-related suspension holes of approx. 5 mm may be present. These serve for fixation during the coating process and are generally located approx. 15 mm from the respective ends. The drill holes are untreated and not deburred. Due to the required suspension hooks, uniform coating in this area cannot be fully guaranteed for technical reasons. This also applies to the end faces of the profiles. Depending on production conditions, the hole may be present on one side, both sides or may be completely omitted; this is determined solely by the respective production process.
For precision applications, an allowance of approx. 50–80 mm should be planned if the entire length is to be used without suspension holes. The required trimming to remove the holes after powder coating is not carried out by us and must be performed by the customer.
Longer and thin-walled components may deform due to their own weight and heat exposure during the coating process. This does not constitute bending in the sense of structural impairment, but rather a deviation from straightness. The components remain functional and fully usable.
The powder coating is applied to all outer surfaces of the legs. This may slightly increase the external dimensions. The coating thickness is approximately 0.06–0.08 mm per side, increasing the leg dimensions accordingly. With additional primer, the total coating thickness may increase.
The sawn end faces are not coated, untreated and not deburred.
Slight colour or surface deviations compared to the product images may occur due to batch variations and may vary depending on display settings.
Login