KAIRO II, welding glove made of split leather, size 10, cat. II, EN 388, EN 12477

The welding glovemade of split leather, comfortable to wear with palm and index finger made of grain leather, pH skin-neutral, tested for harmful substances

Length: 35 cm

Advantages:
Breathable leather
Good wearing comfort
Long cuff protects against sweat beads
Heat resistant
Good thermal behaviour
Good grip properties
Very high tear resistance
High puncture resistance

Examples of use:
Electrical industry
Foundry technology
Vehicle/aircraft construction
Road construction
Craft industry
Mechanical engineering
Metalworking industry

Standards:
Gloves for protection against mechanical hazards according to EN Standard: EN 388:2003
EN 407
General requirements for gloves according to EN 420:2003
Protective gloves for welders EN 12477:2001 + A1:2005

Gloves for protection against mechanical hazards (protection levels achieved on the palm):
3 - Abrasion resistance (0 to 4)
1 - Resistance to cuts (0 to 5)
4 - Tear resistance (0 to 4)
2 - Puncture resistance (0 to 4)
X - Cut resistance according to EN ISO 13997 (A to F) "X" for not tested

Finger dexterity: performance level 5

Water vapour permeability: 13.1mg/cm²h, length: 35 cm

4 - Burning behaviour
1 - Contact heat
3 - Convective heat
X - Radiant heat
4 - Small molten metal splashes
X - Large molten metal splashes

The marking "X" instead of a number means that the glove is not intended for the use covered by this test.